Trouble Shooting; After-Sales Service; Malfunction Table; Accessories For Circulating-Air Mode - NEFF I99L59N0 Instrucciones De Uso

Changing the activated charcoal filter (only in circulating-air
mode)

Trouble shooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
LED lights
Defective LED lights must only be replaced by the
manufacturer, their customer service department or a licensed
technician (electrician).
What to do if water gets in
If water gets in to the appliance during cooking or cleaning,
proceed as follows:
Switch off the appliance.
1.
Open the floor cupboard and mop up leaking water.
2.
Leave the appliance switched off for 24 hours.
3.

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate with these numbers can be
found inside the appliance (remove the metal mesh grease
filter to gain access).
You can make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
E no.
After-sales service O
Please be aware that a visit by an after-sales engineer will be
charged if a problem turns out to be the result of operator error,
even during the warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
FD no.
Hold the edge of the metal clip firmly and pull towards the
1.
middle of the filter.
Take the metal clip out of the holder.
2.
Disconnect the activated charcoal filter from the metal grease
3.
filter.
Secure the activated charcoal filter back to the metal grease
4.
filter with the metal clip.
Installing the metal mesh grease filter
Fit the metal grease filter.
1.
Fit the filter cover.
2.
After this time, the appliance can be used again without
restrictions.

Malfunction table

Problem Possible cause Solution
The appliance The plug is not
does not work plugged in.
Power cut
Faulty fuse
Appliance does Filter cover not
not switch on. closed.
The button illu- The control unit
mination does is faulty.
not work.
The lighting The bulbs are
does not work. faulty.
To book an engineer visit and product advice
0844 8928989
GB
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to 6 pence
may apply.
01450 2655
IE
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.

Accessories for circulating-air mode

(not included in the delivery)
Connect the appliance
to the electricity supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse
for the appliance is OK
Close the filter cover
fully.
Call the after­sales serv-
ice.
Call the after­sales serv-
ice.
Z5159X1
15