TRAPP TRP 30 Manual De Instrucciones página 43

www.trapp.com.br
Additional Safety and Operation Instructions
Make sure the voltage of the power source is the
 
same of that of the equipment (TRP 30/TRP 40/
TRP 400E).
Carefully read instructions and get familiar with
 
the controls and proper used of the equipment.
Remember that the operator or user is responsible
 
for any accident or damage involving people or
their properties.
Do not operate the equipment barefooted or with
 
sandals.
Always wear adequate shoes and pants, goggles,
 
gloves and ear plugs.
Avoid operating the equipment in humid places.
 
Use the equipment in a well lit environment.
 
Before feeding any kind of foliage, start the motor
 
and wait for it to reach maximum revolution.
Do not introduce anything in the equipment with
 
the motor off.
Do not use the equipment during periods of
 
power supply failure.
Whenever cleaning or servicing, make sure the
 
motor is off and the blade is still. Then unplug the
equipment.
If the equipment starts to vibrate, turn it off and
 
immediately unplug it. Check the cause of the
vibration as it indicates that the equipment needs
adjustment and repair.
Attention!
Frequently check if all screws are well
tightened, mainly the counter cutting blade
one. Always keep the counter cutting blade
adjusted to assure the good performance of
the shredder.
Check the status of the power supply cord. Never
 
fix it with insulating tape.
Never use a water jet to clean the equipment. Use
 
a damp cloth and detergent neutral. Water inside
the equipment can damage the electric circuit
of the motor, besides increasing the risk of an
electric shock.
Never operate the shredder with the cover open
 
or without the belt protection guard.
Do not allow people that are not familiarized
 
with the equipment to use it. The equipment
may become dangerous in the hands of people
not familiar with its operation.
Use the equipment according to the instructions
 
in this manual. Take in consideration the
working conditions and the service to be done.
Clean shredder periodically to avoid buildup
 
of residue.
Using the equipment for activities not covered in
 
this manual may result in dangerous situations.
The shredder TRP 400G is equipped with a
 
four-cycle explosion motor - It does not use oil
mixed with the gasoline.
The engine leaves the factory without oil and
 
gasoline (TRP 400G).
Spare parts - Always call TRAPP technicians for
 
spare parts and maintenance services.
43