TRAPP TRP 30 Manual De Instrucciones página 55

www.trapp.com.br
Ensure that there is oil in the crakcase and that it is
 
at the correct level.
Check whether there is fuel or diesel in the tank.
 
Carefully pull the retractable start rope until you
 
find some resistance, then pull it all the way
through. Repeat this operation until the motor
starts.
Allow the motor to heat up for some minutes.
 
Operate the accelerator lever and start working.
 
Establish the temperature range foreseen before
next change of oil. All oils must correspond to API
SG-SL classification.
1. Equipment must be on a flat and level surface.
2. Hot oil will drain better.
3. Collect used oil in proper container.
Operation - TRP 400G
Changing the Oil - TRP 400G
In order to turn the engine off, just release the
 
retractable brake handle.
Notes:
Do not use the injector when the engine is hot,
 
after a period when it has been disconnected.
This engine has an automatic acceleration
 
system, which allows greater economy of fuel.
The engine does not respond upon being
 
accelerated without a load (work force). The
rotation only increases when the machine
is made to work (under no circumstances
should the pressure of the original spring of the
accelerator be altered).
(*) When the engine is hot do not use the choke, only
use the choke when the engine is cold to facilitate the
departure.
Note: for further information on the operation, refer to
the motor manual.
55