TRAPP TRP 30 Manual De Instrucciones página 48

Checking:
Before operating the shredder check:
If there are tools or objects on the motor or on the
 
equipment, mainly inside the grain funnel or in
the green crop feeder.
If there is something obstructing the motor.
 
If the rotation direction is correct.
 
If the voltage of the power source is the same of
 
that of the shredder.
Grounding the TRP 30, TRP 40 and the TRP 400E
!
48
Operation Instructions
Use TRAPP ORIGINAL PARTS.
TRAPP does not undertake responsibility for eventual damages
caused to the equipment, neither for accidents that may occur due
to the use of non-original parts.
If there are people or objects near pulleys and
 
belts.
If the shredder cover is properly closed.
 
If the counter cutting blade is properly set and
 
tightened (pg. 50).
Note:
if the equipment is properly prepared, start
the motor, allow it to reach maximum revolution
and start working.
Grounding point
Note: this grounding point is in the same position on
both machines.
ATTENTION!
www.trapp.com.br