Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Attention!
If motor is hot when changing oil, be careful to
remove oil container. Hot oil is released with
more pressure, and may cause burns.
4. When oil has been fully drained, screw back oil
container.
5. Remove cover (1) and fill up with oil. Replace
cover.
1
Warning!
All maintenance and cleaning should be made
with the equipment switched off and the spark
plug wire disconnected.
The air filter shall be always clean for the engine to
work perfectly.
Blocking of the filter due to lack of cleaning causes
serious operating problems for the engine, among
them loss of power, and damage to the cylinder,
piston and piston rings.
56
6. Check the level of oil with indicating rod (2). For
Air Filter - TR 400G
Air filter - foam
Air filter - paper
better reading, firmly hold cover on tube before
removing the rod. Keep oil at rod " Full " level.
Note:
Frequently check level of motor oil to
prevent damage due to lack of oil.
Dip and tighten (do not twist) it in a solution of
neutral detergent water, removing all the dirt.
Dry it, rolling and pressing it in a dry cloth (do
not twist it).
Moisten the filter slightly with clean oil (20W-50),
always pressing it to distribute the oil equally,
removing the excess.
Pass compressed air from inside to outside the
filter or knocking its base lightly against a flat
surface.
www.trapp.com.br
2
Publicidad
Tabla de contenido
