Descargar Imprimir esta página

Broan Elite E64000 Serie Manual De Instrucciones página 2

Ocultar thumbs Ver también para Elite E64000 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Z\ WARNING
Z\ WARNING
TO
REDUCE
THE
RISK
OF
FIRE,
ELECTRIC
SHOCK OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1.
Use this unit only in the manner intended by the
manufacturer.
If you
have
questions,
contact
the
manufacturer at the address or telephone number
listed in the warranty.
Before
servicing
or cleaning
unit,
switch
power
off at service panel and lock service disconnecting
means
to prevent power from
being switched
on
accidentally. When the service disconnecting means
cannot
be
locked,
securely
fasten
a prominent
warning device, such as a tag, to the service panel.
Installation
work
and
electrical
wiring
must
be
done by qualified personnel in accordance with all
applicable codes and standards, including fire-rated
construction codes and standards.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent backdrafting. Follow the
heating
equipment
manufacturers
guidelines
and
safety standards
such as those published
by the
National Fire Protection Association (NFPA), and the
American
Society
for Heating,
Refrigeration
and
Air Conditioning Engineers (ASHRAE), and the local
code authorities.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
Do not use this unit with any additional solid-state
speed control device.
8.
To reduce the risk of fire, use only metal ductwork.
9.
This unit must be grounded.
TO
When applicable local regulations comprise more
restrictive
installation
and/or
certification
requirements,
the
aforementioned
requirements
prevail on those of this document and the installer
agrees to conform to these at his own expenses.
REDUCE
THE
RISK
OF
A
RANGE
TOP
GREASE FIRE:
a)
b)
c)
d)
Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that
may ignite. Heat oils slowly on low or medium settings.
Always turn hood ON when cooking at high heat or
when flambeing food (i.e.: Crépes Suzette, Cherries
Jubilee, Peppercorn Beef Flambé).
Clean ventilating fans frequently. Grease should not
be allowed to accumulate
on fan, filters or exhaust
ducts.
Use proper pan size. Always use cookware appropriate
for the size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS
INTHE EVENT OF A RANGE TOP GREASE FIRE,
OBSERVE THE FOLLOWING':
1.
SMOTHER
FLAMES
with a close-fitting lid, cookie
sheet or metal tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. IF THE FLAMES
DO NOT GO OUT IMMEDIATELY, EVACUATE AND
CALL THE FIRE DEPARTMENT.
NEVER
PICK
UP A FLAMING
PAN - You may
be
burned.
DO
NOT
USE
WATER,
including wet dishcloths or
towels — This could cause a violent steam explosion.
Use an extinguisher ONLY if:
A. You own a Class ABC extinguisher and you know
how to operate it.
B.
The fire is small and contained in the area where
it started.
C. The fire department has been called.
D. You can fight the fire with your back to an exit.
" Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1.
2.
3.
10.
11.
For indoor use only.
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
To avoid motor bearing damage
and noisy and/or
unbalanced impellers, keep drywall spray, construction
dust, etc. off power unit.
Your hood motor has a thermal overload which will
automatically shut off the motor if it becomes overheated.
The motor will restart when it will be cooled down. If
the motor continues to shut off and restart, have the
hood serviced.
For best capture of cooking impurities, the bottom of
the hood should be at a minimum of 24' and at a
maximum of 30" above the cooking surface.
Two installers are recommended because of the large
size and weight of this hood.
To reduce the risk of fire and to properly exhaust air,
be sure to duct air outside — Do not exhaust air into
spaces within walls or ceiling or into attics, crawl
space or garage.
This product is equipped with a thermostat which may
start blower automatically. To reduce the risk of injury
and
to prevent
power
from
being
switched
on
accidentally, switch power off at service panel and
lock or tag service panel.
Because of the high exhausting capacity of this hood,
you should make sure enough air is entering the house to
replace exhausted air. Use an appropriate make-up
air device or open a window close to or in the kitchen.
To
reduce
the
risk of fire and
electric shock,
the
Broan
Elite
E64E
Series
hood
must
be
installed
with one Broan exterior blower model 331H, 332H,
335
or 336;
or one
Broan
in-line blower
models
HLB3,
HLB6,
HLB9,
HLB11. Other blowers cannot
be substituted. (Exterior or in-line blowers are sold
separately.)
Please read specification label on product for further
information and requirements.

Publicidad

loading