TOPDON Phoenix Smart Manual De Instrucciones página 45

Q: There is no power in the Phoenix MDCI Pro dongle after connecting to the vehicle's DLC port.
A:
Possible Cause
Poor contact of the Phoenix MDCI Pro
dongle.
Poor contact of vehicle's DLC port.
Too low voltage of the vehicle battery.
Fuse blown.
Q: The tablet cannot establish a connection with the Phoenix MDCI Pro dongle.
A:
Possible Cause
Poor contact of the Phoenix MDCI Pro
dongle.
The firmware is damaged.
42
Solution
Plug out the Phoenix MDCI Pro
dongle, and then plug it in again.
Plug out the Phoenix MDCI Pro
dongle, and then plug it in again.
• Recharge the vehicle battery.
Replace the vehicle battery if it
•
is damaged.
Check the fuse of the OBD module.
Solution
• Plug out the Phoenix MDCI Pro dongle,
and then plug it in again.
• Perform the Phoenix MDCI Pro
Bluetooth pairing again.
Enter the settings and tap "Fix Connector
Firmware/System" to fix the firmware.