Bestron DYL1600E Manual Del Usuario página 28

Accessoiries
This vacuum cleaner is supplied with one combined accessory:
• a crevice tool with a narrow nozzle, which you can use to clean radiators,
window frames, crevices, small openings, and similar;
• a dusting brush, which you can use to clean delicate or irregular surfaces,
furniture, Venetian blinds, and similar.
Figure 7
operAtion - storage after use
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in; the
power cord will automatically rewind onto the reel.
Guide the power cord whilst it rewinds onto the reel,
since otherwise the cord could become tangled or
the plug could strike the back of the appliance. Take
hold of the power cord near the mark, and allow it
to gently slide through your fingers back into the
appliance, see Figure 8.
3. Stand the vacuum cleaner upright. An
attachment slot for the accessory bracket is
fitted to the back of the vacuum cleaner next to
the front castor (see Figure 9). Slide the bottom
of the combi-brush bracket into the slot. This
avoids the need to dismantle the vacuum
cleaner after use; you can store the assembled
appliance and retrieve it again quickly when
you need it.
cleAninG And MAintenAnce - cleaning
1. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics. Make sure no
moisture gets into the appliance.
2. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
cleAninG And MAintenAnce - changing the dust bag
1. Change the dust bag immediately once the 'dust bag full' indicator turns red, see Figure 10.
It is possible that the indicator turns red whilst the dust bag is not yet full.
if so, then the nozzle, hose or tubes may be blocked. These will then
need to be cleaned.
2. Open the cover by pulling the cover release (dust bag) upwards.
Remove the dust bag from the holder, and dispose of it in a dustbin.
3. Fit a new dust bag in the holder with the arrow pointing downwards,
and press into position.
4. Close the cover, and press until it clicks into place.
Make sure that the dust bag does not become pinched by the cover.
This could damage the appliance and/or the dust bag.
Note Dust bags for this vacuum cleaner are available from every major hardware store.
28
user's instructions
Figure 8
Figure 9
Figure 10