Installing The Sma Antenna Kit - Dell OptiPlex Small Form Factor 7010 Manual Del Usuario

3. Remove the antenna cables from routing guides on the system board.
4. Remove the external SMA antenna kit off the system board.

Installing the SMA antenna kit

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the external SMA antenna kit and provides a visual representation of the
installation procedure.
Steps
1.
NOTE: Steps 1, 2, and 3 are required when installing the external SMA antenna kit for the first time.
86 Extracción e instalación de unidades reemplazables en campo (FRU)