Publicidad
™
3M
Digital Media System 700 Series
• To reduce the risk associated with exposure to hazardous voltage:
- Do not remove any screws other than those specified in the lamp replacement instructions.
• To reduce the risk associated with hazardous voltage:
- Do not operate this projector in wet environments or outdoors.
- Do not modify this projector or power cord.
- Do not attempt to service the projector; other than the lamp cartridge there are no user
serviceable parts inside the projector.
- Contact a 3M authorized service provider for service.
- Disconnect power cord when the projector is not in use, during lamp replacement, and while
cleaning.
- Do not allow water or other liquids to enter the projector.
• To reduce the risk associated with hazardous voltage and/or fire:
- Replace power cord if damaged.
- Contact a 3M authorized service provider if the projector becomes damaged.
- Use a grounded extension cord with a rating at least equal to that of the projector.
- Connect this projector to a grounded outlet.
• To reduce the risk associated with hot surface of lamp cartridge:
- Unplug the projector from the electrical outlet and allow the lamp to cool for 60 minutes before
replacing the lamp.
• To reduce the risk associated with choking:
- Keep the battery and battery cover away from children and pets.
• To reduce the risk associated with environmental contamination due to mercury:
- Hg: Lamp contains mercury. Don't throw in trash. Dispose according to local, state, or federal laws.
See www.lamprecycle.org or call 1-800-328-1371.
• To reduce the risk associated with lamp rupture related hazards:
- In event of lamp rupture, call 3M authorized service provider for repair. Ruptured lamp repair is
not user serviceable.
- Wash your hands thoroughly if contact with ruptured lamp debris has taken place.
- Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
• To reduce the risk associated with hazard voltage, and/or impact, and/or tripping, and/or
intense visible light:
- Do not use this projector around unsupervised children.
• To reduce the risk associated with sharps, premature lamp failure, exposure to mercury:
- Always handle the fragile lamp module with care.
- Replace the lamp module when the lamp replacement message appears.
- Never replace the lamp module with a previously used lamp module.
© 3M 2007. All Rights Reserved.
WARNING
Introduction
7
Publicidad
