Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting the camera
➤ Align the camera so that the lens is at an angle of approx. 20° to the vertical axis
of the vehicle (fig. k, page 8).
I
NOTE
Do not tighten the four M3 x 8 mm screws until you have aligned the
camera (see chapter "Checking the function and setting the camera" on
page 25).
To do this you must first install and connect a monitor.
8.3
Connecting the camera
I
NOTE
• Lay the camera cable so that should you need to remove the camera,
you can access the plug connection between the camera and the
extension cable easily. This considerably eases dismantling work.
• To minimise corrosion in the plug, apply a small amount of grease –
such as pin grease – inside the plug.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable.
➤ Screw on the plug connections of the connecting cables to protect against water
penetration (fig. 0, page 5).
8.4
Connecting the 9102200078 switchbox
(fig. n, page 9)
The switchbox is supplied ready for installation.
➤ Fasten the switchbox at a suitable point.
➤ Connect the control box electrically as follows:
– Connect the camera inputs on the monitor to the "V1" and "V2" connections.
– Connect the system cable from the camera to the "TWIN" connection.
The camera is switched on and off in reverse gear or using the camera selection
button on the monitor.
24
CAM44
EN
Publicidad
