Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that your fin-
gers are not placed on the trigger and the battery
cartridge is removed before loading nails.
CAUTION:
Do not abruptly slide the slide
door of the nailer loaded with nails. Accidentally
dropping nails especially when working in high places
may cause personal injuries.
CAUTION:
Load nails in the correct direction.
Loading in wrong direction may cause premature
wear and tear of the driver and damage of the other
parts.
CAUTION:
Do not use deformed nail strips.
Use nails specified in this manual. Using nails other
than those specified may cause nail jamming and
breakage of the nailer.
1.
Press the lock lever and open the slide door of the
magazine.
► Fig.8: 1. Lock lever 2. Slide door 3. Driver guide
4. Magazine
2.
Set a nail strip so that the nail tips touch the bot-
tom of the magazine and slide the nail strip toward the
firing opening.
► Fig.9: 1. Nails 2. Slide door 3. Driver guide
3.
Return the slide door to the original position until
the lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine.
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing nails on the material with easily-marred
surfaces, use the nose adapter. To attach the nose
adapter, put it onto the driver guide cover to the end.
You can store the nose adapter on the holder on the
back end of the magazine to keep it from being lost.
► Fig.10: 1. Nose adapter 2. Holder
Hook
CAUTION:
Do not hang the hook from the
waist belt. Dropping the nailer, which is caused by
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
► Fig.11
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
► Fig.12: 1. Groove 2. Hook 3. Screw
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► Fig.13: 1. Hex wrench
OPERATION
Testing the safety system
WARNING:
Make sure all safety systems are
in working order before operation. Failure to do
so may cause personal injuries.
► Fig.14: 1. Trigger-lock button 2. Switch trigger
3. Contact element 4. Magazine
Test safety systems for possible fault before operation
as follows.
1.
Unload nails from the tool and keep the magazine
opened.
2.
Install the battery cartridge and release the trigger
lock.
3.
Only pull the switch trigger without touching the
contact element against the material.
4.
Only touch the contact element against the mate-
rial without pulling the switch trigger.
If the tool operates in the case of 3 and 4 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.
Driving nails
WARNING:
Do not use this nailer for fasten-
ing electrical cables. It is not designed for electric
cable installation and may damage the insulation of
electric cables thereby causing electric shock or fire
hazards.
WARNING:
Continue to place the contact
element firmly on the material until the nail is
driven completely. Unintentional firing may cause
personal injuries.
9 ENGLISH
Publicidad
