Helite RACE SUIT AIRBAG_E02 Manual De Instrucciones página 30

30
English
11 Close the zippers of the lining.
12
Turn the suit over, the electronic system is in the hump.
Slide the hump into the pocket provided inside the suit.
Place the CDU electronic card in the hump.
13 Connect the remote HMI with CDU electronic card and position it in the over-
mould above the hump.
14 Fold the hump over the back and close the zipper.
c) Check the e-cartridge connection
Check that the cartridge is connected to the CDU electronic card : connector in the
right direction and locked. The elements are located in the hump on the back of
the suit.
d) Select your detection mode : race track or road
On the Race Suit airbag the race track mode
you choose your detection mode according to your application (see page 26):
road mode or race track
mode see page 32.
If you encounter a problem before the first use, please refer to the section
«Meaning of LEDs and Beeps» (see page 37) or to the section «After Sales Service»
(page 39).
mode. To find out how to change your detection
Race track mode actived
The LED flashes pink
Road mode actived
The LED flashes green
is activated by default. Make sure
You can drive on a
regulated closed asphalt
race track.
You can drive on asphalt
road for vehicle traffic.