Helite RACE SUIT AIRBAG_E02 Manual De Instrucciones página 36

36
English
4
Install a new Helite cartridge of the same reference. Insert the cartridge
cable into the cylinder. Be careful not to twist or bend it while screwing it
in, as this could damage it. Screw the cartridge as far as possible. Be careful
not to screw it in crooked. Connect the cartridge to the CDU electronic card
(locking connector), caution plug in the connector in the right way.
5 Replace the cartridge correctly inside
the hump, attaching the velcro of the suit to
the velcro of the airbag*.
Check the correct placement of the airbag
in the suit and close the suit lining.
*Disregard this procedure if you are
accessing the cartridge from the outside
of the liner.
6 Turn on the airbag (press the ON/OFF
or button 3 times) :
• If a green (road mode) or pink (track
mode) LED is flashing, the cartridge is
correctly installed. You can use the airbag.
• If a red LED is flashing and you hear beeps,
something is wrong (empty cartridge, cable
not properly connected, etc). In this case,
recheck the cartridge installation and the
condition of the airbag. If the problem persists,
contact your dealer or Helite customer service
at sav@helite.com.
x3
AIRBAG TECHNOLOGY
MAX
x3
AIRBAG TECHNOLOGY