Bimar HF208 Folleto De Instrucciones página 12

that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
The fan heater is equipped with the following adjustment devices:
The appliance comes with a thermostat, selector switch, indicator light, tipping switch and
safety device:
- the selector switch controls the following:
"0" = off; " "= fan on; "
- the thermostat adjusts the ambient temperature, and
is greater when the selector is turned towards the
maximum position (clockwise direction): once the
temperature has been reached, it will be kept
constant, while setting it to the lines in between
causes the element to come on at intervals.
- The indicator light turns on and off when the appliance reaches the set temperatures.
- The base has an anti-tipping switch, which allows the appliance to run while the fan heater
is correctly positioned (when correctly placed you will hear it "click") but stops operation if
the appliance tips over.
- safety device: when included it stops operation in the event of overheating. To restore
operation, remove the plug from the mains and wait for it to cool (about 20 minutes) and
insert the plug into the plug point and turn on again.
To use the fan heater, proceed as follows:
1) Plug into the socket.
2) Adjust the thermostat knob (B) to the required ambient temperature.
3) Turn the appliance on by turning selector switch (A) clockwise to the required setting.
4) To switch off the appliance: turn the selector to (
minutes in order to cool down the element (doing so will increase durability), then turn the
fan off by turning the knob to "0" (off). Lastly, always remove the plug from the mains.
If the appliance is not being used for long periods of time, remove the plug from the plug point.
CLEANING AND MAINTENANCE
Warning: before cleaning the appliance, turn it off, remove the plug from the plug point and
wait until it cools down.
• To ensure proper operation of the appliance, periodically check that the rear ventilation grille
is not blocked by fluff or threads: this should be done after removing the plug from the mains;
If necessary, use a vacuum cleaner, taking care not to damage the element.
• To clean the main outer casing using a soft, damp cloth; do not use steel wool or abrasive
products.
• If the fan heater is not used for long period of time, cover it and store it in a dry place; it is
advisable to place it in the original packaging to protect it from dust and moisture.
"= hot air (1000W); "
12
"= very hot air (2000W)
), allow only the fan to run for about 3