Publicidad
4. ATTACH THE PEDALS (HANDLEBAR DUAL ACTION MOVEMENT)
NOTE: The right pedal (12R) has R marked on the bottom side of the pedal. The left pedal (12L)
has L marked on the bottom side of the pedal. Both pedals (12L/R) have right hand threads.
Tighten both pedals (12L/R) by turning clockwise.
Slide the two pedals washers (11) onto both pedal shafts of pedals (12L/R)
Insert pedal shafts of pedals (12L/R) through the linkage bars (10).
Slide spacers (9) onto pedal shafts. Warning: spacers (9) must be between linkage bar (10)
and crank (50) so that there will be enough clearance between linkage bar (10) and
crank (50).
Thread pedal shafts of pedals (12L/R) into crank (50) and tighten.
Hold pedal shafts and thread locknut 1/2" (8) onto pedal shafts.
Tighten pedal shafts and locknut 1/2" (8) until locknut 1/2" (8) are tight against crank (50).
5. ATTACH THE MONITOR
Attach the plug of sensor wire to socket of monitor wire which comes from monitor (31) to
the sensor wire (38) which comes fron main frame (1).
Connect the monitor (31) with monitor bracket (30) to the main frame (1) using 2
screws (64).
RECHECK THAT ALL THE BOLTS AND NUTS ARE TIGHTENED SECURELY FOR
YOUR SAFETY AND COMFORT.
5
5
Publicidad
