Footrests, Legrests & Footplates; Seating And Seat Sling Upholstery - Sunrise Medical Breezy Ultra 4 Manual De Instrucciones

B REEZ Y UL TRA 4
J. FOOTRESTS, LEGRESTS, & FOOTPLATES
Make sure that your Authorized Dealer has correctly adjusted your footrests and/or legrests with the advice of
a healthcare professional. The original setup should not be changed without first checking with your healthcare
professional. The footrest position is key to keeping your body in the proper alignment, and providing a stable
support for your legs and torso. Legrests and footrests should be swung out of the way, or removed for trans-
fers.
Swing-in Swing-out hangers and footrests
1. Basic Footrest Installation
a. Place the swing-in/swing-out footrest onto the two receiver pins(A) on the front frame tube with the
footrest facing outward from the frame.
b. Rotate the footrest inward until you hear it lock into place on the locking plate.
20
2. Removal
a. To remove the footrest, push on the lever (B) to unlock.
b. Rotate the footrest inward or outward and lift it off of the chair.
3. Footplate height adjustment
a. To adjust the footplate, release the anti-rattle lock(C) by pushing the lever downward.
b. Push in both detent buttons and slightly rotate the footrest tube so that it can be moved to the
appropriate height
c. Adjust the other side using the previous steps if needed.
22
4. ELR installation
a. Place the ELR on to the two receiver pins (A) on the front frame tube with the footrest facing outward
from the frame.
b. Rotate the ELR inward until you hear it lock into place on the locking plate.
c. Install the other side using the previous steps if needed.
5. Elevating legrest adjustment
a. To adjust the elevating legrest, raise the legrest until the desired height is obtained.
b. To re-position the legrest, support the leg with one hand and push the release Lever(E) downward with
the other hand.
c. To adjust the calf pad height, turn it towards the outside of the wheelchiar and slide it up or down to one
of the three pre-configured slots (F)
K. SEATING AND SEAT SLING UPHOLSTERY
The seat sling is not a seating surface. It is recommended that an appropriate wheelchiar cushion be used with
the wheelchair for proper protection of the skin and reduction in the possibe occurance of pressure sores that
can develop when seated for long durations.
1. Seat Sling Upholstery
a. Check monthly for excessive stretching of the upholstery, or loose attaching hardware. If you determine
the upholstery can no longer be adjusted tight, contact your Authorized Dealer for a replacement.
2. Custhion Installation
a. Place cushion on the seat sling with the hook material side down. The beveled edge of the cushion
should be facing toward the front of your chair.
b. If the bottom of your cushion has a loop material, you can use the two sided hook material provided (G)
to attach to the sling as shown.
c. Press the cushion firmly into place.
MK-100078 RevA
19 20
19
21
23
WARNING
21 22
16
VIII. USE AND MAINTENANCE
A
B
C
F
19
20
21
D
22
23