Publicidad
Idiomas disponibles
Idiomas disponibles
Wiring Instructions for Electrified Central Vacuum Inlet Valve Continued..
7. Connect Low Voltage Wires (3) under Contact
4. Install Building Wire Conductors (1) (A.C. Power)
Screws (4) of Inlet Valve Face Plate.
through the approved type electrical box connector
(2) until they
protrude
approximately
6" through
8. Push
inlet Valve
Face
Plate (7) to Mounting
connector into the Wiring Compartment (9).
Plate
(8).
At
same
time
push
Building
Wire
Conductors
(1) and
connectors
(6)
into Wiring
5. Loosen
the screws
(12) that hold the bottom
Compartment (9).
Cover Piate (14) (marked "DO NOT REMOVE") so
that slotted tabs of finished Wall Clip (15) can be
9. Secure Inlet Value Face Plate (7) to Mounting
places behind the screw heads.
Plate
(8)
using
the
2
supplied
color
matched
Screws (10).
6. Position the modified Mounting
Plate with the
Finished C
tructi
short
Ell
glued
on
and
the
Low
Voltage
and
inished
Vonstruction
Building Wired (3) and (1) protruding through it,
After pipe, Low Voltage Wire () Electrical Building
Wire (1) (A.C. Power) are in place and opening in
wall has been carefully exactly cut (page 8):
into the wall opening, and then glue it to the tubing
(as on page 8).
7. Slip tabs of Finished Wall Clip (15) behind screw
heads (12) and then tighten screws.
Note: this Clip will retain Mounting Plate in wall and
2. Glue 90° Ell over projecting socket on the back
—_allow for easier electrical connections.
of Mounting Plate (8) (as on page 8.) (Position with
wiring compartment on top.)
1. Remove mounting plate nailing flange (11) (see
page 8).
8. Follow steps 6-9 from new construction.
3. Push
Low Voltage Wires
(3) through
hole in
lower Cover Plate (14) from back side.
eh
a=
To obtain approved
Hoover® service and genuine Hoover® parts, locate the nearest Authorized Hoover®
Warranty Service Dealer (Depot) by:
* Checking the Yellow Pages under "Vacuum Cleaners" or "Household".
+ Visit our website at hoover.com. Follow the service center link to find the service outlet nearest you.
* For a referral of authorized service outlet locations call 1-800-944-9200.
Do not send your vacuum to Hoover®, Inc., Company in Glenwillow for service. This will only result in delay.
If you need further assistance:
To speak with a customer service representative call 1-800-944-9200; Mon-Fri 8am-7pm EST.
Always identify your vacuum by the complete model number when requesting information or ordering parts.
(The model number appears on the side of the Power Canister.)
Please do not return this product to the store.
12
Publicidad
