Publicidad
Idiomas disponibles
Idiomas disponibles
Right Angle Drill and Drill Extensions
In
confined
areas
it
may
be
necessary
to
use a right angle
drill
(3.3) or drill extensions
to
reach
the
desired
area
(3.4).
When
boring
through
a
firebreak,
make
sure
the hole is in line with
the
hole
through
the
header or floor plate.
PP nk Com ta
a
wa
a,
Installing Mounting Plates
(For
electrified
valve
mounting
plates
see
page 11)
3.5 If kit comes with a plastic plate, cut mounting
plate along dotted lines with a hacksaw or score
with a razor knife and break flange off.
3.6 If kit comes with a metal mounting plate, snip
off the four plastic tabs and remove the metal plate.
Use a coat hanger pushed through the pilot hole
(3.2) to be sure opening for inlet valve will be in line
with the 2-1/2" tubing hole.
3.7
Using
raised
edge
of mounting
plate
as a
template, trace exact opening on wall (about the
same height as electrical outlet). Cut opening.
Note: Trace this edge only.
Note: Be exact in cutting opening as there is very
little overlap on the mounting plate.
Installation of mounting plates and inlet valves may
vary with other manufactures.
Insert tubing and low voltage wire up through hole
in
floor
plate
to
inlet
valve
opening.
Leave
approximately eight (8) inches of wire at inlet vaive
opening. Secure wire to prevent it from falling back
through hole.
Glue short 90° elbow over projecting
socket on
back of mounting plate, matching lines on elbow
with those on plate for correct angle.
3.8 Grasp mounting plate between first two fingers
and thumb and put plate through wall opening. Pull
wire through
opening
in upper part of mounting
plate.
3.9 Pull plate forward,
positioning
it snugly
into
opening.
While
mounting
plate
is being
held
in
place,
another person
should
remove
tubing from
hole
and apply adhesive to end. Reinsert tube and push
it firmly into the elbow. Tube can be guided in place
with fingers inserted into vaive opening.
Publicidad
