Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALL
SUPPORT
SYSTEM
1. At hood location, install 2 x 4 cross framing
between ceiling joists
using dimensions
shown.
2. Finish the ceiling surface. Be sure to mark
the location of the ceiling joists and cross
framing.
3. Position the support frame as shown. The
UP ARROW should point towards the ceiling
after installation.
4. Secure the support flame to joists and cross
framing with four screws provided (6x70mm)
and four washers (D. 6.4mm). Make sure
screws are driven into center d joists and
framing for maximum strength.
5. Adjust the overall height d the support flame.
(6x70m
Loosen and re-tighten the 4 screws in the
height
adjustment
slots
as necessary.
Insert 4 screws (3.9x9.5mm) and 4 washers
(D.4.5mm)
located
in the
Hardware
FRONT
Package.
Note that the hood height is 10-1/4" and that
the bottom of the hood must be 24" min. and
30" max. above the cooktop.
DRYWALL
\.
CROSS
FRAMING
JOISTS
I
I
I
I
FRAME
HEIGHT ADJUSTMENT
SLOTS
TOP VmEW OF SUPPORT
FRAME
10q8" (276mm)
!'!
!
71s/16"
(198mm)
CONNECT
DECORATIVE
FLUE
1. Secure the upper flue to the upper support
frame
with
the
mounting
screws
(3,9x9,5mm).
2. Insert the lower flue moving it completely
towards the top and fix it temporarily with
retaining screw (3.9x9.5mm).
_
iNSERT ;HE E LOWER
L
..4_ _
R?NING
SCREW
MOUNTmNG SCREWS
(3.9X9,5MM)
UPPER FLUE
__
LOVVER
FLUE
-7-
Publicidad
