Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING
_
CAUTION: All electrical wiring should
be done
by a qualified
person
(s) in
accordance
with all applicable codes and
standards.
This
range
hood
must
be
properly grounded.
Do not turn power on at service panel until
all wires have been connected.
Blower connection at hood:
1. Run 2-wire plus ground power cable from
the exterior or In-Line Blower blower to the
hood's
wiring
box
marked
"motor
connection".
2. Remove the cover from the wiring box and
remove one knockout.
3. Feed 6" of cable through
the knockout
opening and secure the cable to the wiring
box with an appropriate connector.
4. Make electrical connections
at the hood.
Connect white-to-white,
red-to-black
and
green-to-ground.
5. Replace the wiring box cover and screws.
make sure wires are not pinched between
the cover and box.
BLOWER CONNECTION
AT HOOD
CONNECT:
WHITE-TO-WHITE,
RED-TO-BLACK,
GREEN-TO-GROUND.
Exterior or In-Line
blower
BOX MARKED
"MOTOR
CONNECTION"
Exterior or In-Line blower connection:
1. Make electrical connections at the exterior
or In-Line blower(see instructions provided
with the exterior or In-Line blower).
Power connection
at hood:
1. Run 120 VAC electrical power cable to the
hood wiring box marked "120VAC input".
2. Remove the cover from the wiring box and
remove one knockout.
3. Feed 6" of cable through
the knockout
opening and secure the cable to the wiring
box with an appropriate connector.
4. Make electrical connections
at the hood.
Connect
white-to-white,
black=to=black
and green-to-ground.
5. Replace the wiring box cover and screws.
Make sure wires are not pinched between
the cover and box.
POWER CONNECTION AT HOOD
BOX MARKED
"120 VAC INPUT"
120 Volt 60Hz
LINE-IN
CONNECT:
WHITE-TO-WHITE,
BLACK-TO-BLACK,
GREEN-TO-GROUND.
-9-
Publicidad
