Sennheiser RS 40 Instruciones Para El Uso página 6

Wireless RS 40
Thank you for choosing Sennheiser! Over half a century of accumulated expertise
in the design and manufacture of high-quality electro-acoustic equipment have
made Sennheiser a world-leading company in this field. We have designed this
product to give you reliable operation over many years.
Please take a few moments to read these instructions carefully, as we want you to
enjoy your new Sennheiser product quickly and to the full.
System components and connections
- 1 receiver HDR 40
- 1 transmitter T 40
- 1 rechargeable battery BA 151
- 1 power supply
- 1 mini jack plug 3.5 mm with adaptor to 1/4"
6.3 mm ( 935 MHz jack to 2x phono plug)
- 1 instruction manual
Establish the necessary connections.
Charge the accupack for 24 hours before you
use it for the first time! (Please refer to the
section Charging the accupack.)
Where to place the transmitter
Choose a suitable place near your hi-fi system
or TV set.
Do not place the transmitter close to metal
objects such as shelf bars, reinforced concrete
walls, etc.
The transmitter features a convenient automatic
on/off function. The transmitter is switched on
by the audio signal. If there is no audio signal for
about 3 minutes, the transmitter automatically switches off. The transmitter is now
in stand-by mode, its power consumption is very low so that it can remain
connected to the mains. Accupacks can always be recharged when the transmitter
is connected to the mains.
Switching the headphone receiver on
The O /O switch is on the right earpiece.
N FF
Switching the headphone receiver off
Make sure to switch off the headphones after
each use and store the headphones in the
transmitter's charging compartment to avoid
discharging the accupack.
Wireless RS 40-7