Ford SKLX6J-19D520-BA Instrucciones De Montaje página 4

EN
INSTALLATION INSTRUCTIONS –
TOW BAR DETACHABLE KUGA 01/2020 ➜
Type:
D-value:
Bearing load:
Manufacturer:
EEC type approval no.:
Area of application:
Off . type designation:
Note:
Check before ordering and fi tting whether a
maximum towing load has been specifi ed in the
!
vehicle documents.
Your Ford dealer will be pleased to help you.
Note:
Fitting is to be executed in accordance with these
instructions.
When using the trailer hitch, always observe the
manufacturer's data regarding trailer load and vertical
load. The fi gures stated for the trailer hitch must not
be exceeded.
Formula for ascertainment of D-value:
Trailer mass [kg] x gross vehicle mass [kg]
––––––––––––––––––––––––––––––––––––– x ––––– = D [kN]
Trailer mass [kg] + gross vehicle mass [kg]
The maximum permissible combined weight of vehicle and
trailer must not be exceeded. The maximum permissible
weight for the car-trailer combination is stated on the
vehicle's identifi cation plate. Your Ford dealer will be
pleased to help you if required.
XXXX kg
Before using the coupling device, the correct trailer
electrical kit must be installed.
It is recommended to install the electrical kit before fi tting
the trailer coupling.
In the area of the contact surfaces, undersealing, anti-
corrosion wax and noise-deadening material must be
removed. If necessary, apply corrosion protection according
to Ford Service guidelines.
Disconnect earth lead from battery. Jack the vehicle.
Note: The bolts and screw threads used to bolt
the tow bar to the bodywork must be free from oil
!
and grease!
SKLX6J-19D520-BA
4/36
6212
11,23 kN
100 kg
Brink Towing Systems B.V.
7951 CX Staphorst,
the Netherlands
Industrieweg 5
E11*55R01/07*11469*00
Ford KUGA 01/2020
➜
DFK
9,81
1000
Operating notes:
The coupling ball must be kept clean and well greased (*).
(*) Exception:
When stabilisers are in use which act on the coupling ball,
pro-ceed according to the instructions of the manufacturer
of the stabilisers. When stabilisers are in use, the coupling
ball must be inspected for wear at regular intervals.
As soon as a coupling ball diameter of 49.0 mm or smaller
has been reached at any point, the towing device must no
longer be used in trailer operation; if necessary, the towing
device must be renewed.
The unladen weight of the vehicle will increase by appr. 22 kg
following mounting of the towing device.
©
Copyright Ford-Werke GmbH, 2019