Console (fig F)
1
3
2
1.
Display
2.
Tablet/ book support
3.
Buttons
⚠ CAUTION
•
Keep the console away from direct sunlight.
•
Dry the surface of the console when it is
covered with drops of sweat.
•
Do not lean on the console.
•
Only touch the display with the tip of your
finger. Make sure that your nails or sharp
objects do not touch the display.
‼ NOTE
•
The console switches to standby mode when
the equipment is not used for 4 minutes.
Explanation Display functions
Time
- Without setting the target value, time will count
up.
- When setting the target value, time will count
down from your target time to 0 and alarm will
sound or flash.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, time will
STOP
- Range 0:00~99:59
Speed
- Displays current training speed.
Maximum speed is 99.9 KM/H or ML/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED
will display "0.0"
RPM
- Displays the Rotation Per Minute.
Display range 0~15~999
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
WATTS
- Display current workout watts.
- Range 0 ~ 999
LOAD
- Shows tension level setting, when adjusting
resistance, for 3 seconds.
Distance
- Without setting the target value, distance will
count up.
- When setting the target value, distance will
count down from your target distance to 0 with
an alarm sound or flash.
- Range 0.00~99.99
Calories
- Without setting the target value, calorie will
count up.
- When setting the target value, calories will
count down from your target calorie to 0 with
an alarm sound or flash.
- Range 0~9999.
‼ NOTE
•
This data is a rough guide for comparison of
different exercise sessions which cannot be
used in medical treatment
Pulse
- Current pulse will display after 6 seconds when
detected by the console.
- Without any pulse signal for 6 seconds, console
will display "P".
- Pulse alarm will sound when current pulse is
over the target pulse.
- Range 0-30~230 BPM
English
17