HERKULES 43.406.61 Manual De Instrucciones Original página 16

Anleitung UFZS 1800 SPK 7:-
GB
5. Technical data
AC motor
Power P S1 1500 W S6 40% 1800 W
Idle speed n
0
Cutting-off wheel
Number of teeth
Table size
Drag length
Cutting height max.
Height adjustment
Tilting saw blade
Extractor socket
Weight
Noise emission values
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
16
07.10.2010 8:14 Uhr
230V - 240V 50Hz
4300 min -1 6. Before putting the machine into
Ø 250 x Ø 30 x 2.4 mm operation
48
660 x 456 mm
220 mm
73 mm / 0°
50 mm / 45°
infinite 0 -73 mm
infinite -2° -47°
Ø 35 mm
33 kg
97,7 dB(A)
3 dB
109,3 dB(A)
7. Assembly
3 dB
Important! Pull out the power plug before
carrying out any maintenance, resetting or
assembly work on the cutting-off machine!
7.1 Assembly
7.2 Fitting / removing the saw blade guard (Fig.
Seite 16
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong base.
All covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
Place the saw on a flat and firm surface.
Fasten the extractor adapter (16) with the 2
screws (35) to the back of the saw as shown in
Fig. 5.
Fit the extension pipe (50) for the lower dust
extraction device and the short extractor hose
(51) to the extractor adapter and extension pipe.
2/3)
Mount the saw blade guard (2) on the splitter (5)
so that the screw fits through the hole (44) in the
splitter.
Do not tighten the screw (15) too far – the blade
guard must be able to move freely.
Fasten the extractor hose (13) to the extractor
adapter (16) and to the extractor socket of the
blade guard (2).
A suitable extractor system has to be connected