Disposal; Troubleshooting - Zipper Maschinen ZI-KGS255DS Instrucciones De Servicio

16.4

Disposal

17

TROUBLESHOOTING

Danger due to electrical voltage! Manipulating the machine with the power
supply up can lead to serious injuries or death. Always disconnect the machine
from the power supply before carrying out any troubleshooting work!
Many possible sources of error can be excluded in advance if the machine is properly connected to
the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required training,
always consult a specialist to correct/solve the problem!
.
Fault
Machine doesn't start
Workpiece kick-back
Wrong cutting angle
Saw blade cuts the table
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating materials (like oil,...) in
residual waste. If necessary, contact your local authorities for information
on the disposal options available.
If you buy a new machine or an equivalent device from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
WARNING
 No power supply
 Carbon brushes defect
 Motor defect
 ON-OFF-switch defect
 Dull saw blade
 Wrong assembled saw blade
Angular position not correct

 Incorrect setting of cutting
Possible cause
depth
TROUBLESHOOTING
Correction
Connect to mains

 Exchange carbon brushes
 Exchange motor
 Repair switch
 Replace saw blade
 Check direction / assemble
Adjusting the angular position

 Adjust cutting depth
ZI-KGS255DS
36