Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
16.2.5 Emptying/changing the chip bag
16.2.6 Checking / changing carbon brusher
16.2.7 Exchange table insert
If the table insert (19) is damaged, there is a risk that small parts may become
stucked between the table insert and the saw blade and block the saw blade
16.3
Storage
Improper storage can damage and destroy important components. Only store
packed or unpacked parts under the intended ambient conditions!
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
The machine is equipped with a chip bag for sawdust
and chips.
Attention! The chip collection bag may only be used
for cutting wood and wood-like materials!
Press the metal ring on the chip bag together and
fasten it to the dust collector port. The chip bag can
be emptied by means of a zipper on the underside.
Check the carbon brushes after the first 50 hours of
operation with a new machine or when new brushes
are installed. After performing the first check, repeat
the check every 10 operating hours.
If the carbon is worn to a length of 6 mm, or if the
spring or contact wire is burnt or damaged, it is
necessary to replace both brushes. If it proves that
the brushes can be used after removal, it is possible
to reassemble them.
When servicing the carbon brushes, open the two
covers (13) counterclockwise. Then remove the
carbon brushes. Replace the carbon brushes in
reverse order.
CAUTION
1. Remove screws (S) from the table insert (19). If
necessary, turn the rotary table and machine head to
reach the screws.
2. remove the table insert (19).
3 Install the new table insert (19).
4 Tighten the screws (S) on the table insert (19).
NOTE
35
ZI-KGS255DS
Publicidad
Tabla de contenido
