EFBE-SCHOTT OKB 920 D Manual página 13

CLEANING AND CARE
• Always unplug the device before cleaning!
• Always make sure that the filter glass is undamaged and clean. Stains, dust and
fingerprints can burn in and reduce the efficiency of radiation.
• Clean the filter glass with a clean cloth and methylated spirits.
• If required, clean the housing of the device with a damp (not wet) sponge or cloth.
Repairs
• The filter glass has specially adapted filter characteristics and must be replaced by
an original filter glass when damaged.
• We are not liable for glass breakage even in the case of a new device, nor for any
transport damage to repair devices that have been sent in with inadequate
packaging.
We recommend to keep all parts of the original packaging.
•
• Any repairs, including the replacement of the power cord, may only be carried out
by the manufacturer, its customer service or a similarly qualified technician in order
to avoid any hazards.
Replacement lamp for the tanning device
OKB 920 D: reference of the replacement lamp : HPA 400/30 S IV
Like all fluorescent tubes, radiation lamps contain specific admixtures. Defective radiation
lamps are classed as hazardous waste and must not be disposed of in the household
waste.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
on the rating label or on the packaging, your appliance should not be disposed of as
unsorted municipal waste. The user has the right to bring it to a municipal collection point
performing waste recovery by means of reuse, recycling or use for other applications in
accordance with the directive.
ERP DECLARATION – REGULATION 1275/2008/EC
We, Efbe Elektrogeräte GmbH, hereby confirm that our product meets the requirements
of Regulation 1275/2008/EC. Admittedly, our product does not dispose of a function to
minimize the power consumption, which should according to Regulation 1275/2008/EC
put the product in off or standby mode after finishing the main function, but this is
practically impossible, as it would compromise the main function of the product so
strongly, that using the product would no longer be possible!
For this reason, we always tell the customer in our instruction manual to unplug the
appliance immediately after use.
13