OHAUS Adventurer AX4201/E Manual Del Usuario página 4

1. INTRODUCTION
Thank you for purchasing our product. This user guide will help you install your balance
and use it safely. Please read it carefully before installation and operation. For detailed
instructions, please visit www.ohaus.com/products.
2. SAFETY INFORMATION
This manual contains installation, operation and maintenance instructions for AX Series
balance. Please read this manual completely before installation and operation.
Definition of Signal Warnings and Symbols
Safety notes are marked with signal words and warning symbols. These show safety
issues and warnings. Ignoring the safety notes may lead to personal injury, damage to
the instrument, malfunctions and false results.
WARNING For a hazardous situation with medium risk, possibly resulting in injuries
or death if not avoided.
CAUTION For a hazardous situation with low risk, resulting in damage to the
device or the property or in loss of data, or injuries if not avoided.
Attention For important information about the product
Note For useful information about the product
Warning Symbols
General Hazard
Explosion hazard
Safety Precautions
CAUTION:Read all safety warnings before installing, making connections, or
servicing this equipment. Failure to comply with these warnings could result in
personal injury and/or property damage. Retain all instructions for future
reference.

Before connecting power, verify that the AC adapter's input voltage range and
plug type are compatible with the local AC mains power supply.

Do not position the equipment such that it is difficult to reach the power
connection.

Make sure that the power cord does not pose a potential obstacle or tripping
hazard.

Operate the equipment only under ambient conditions specified in these
instructions.

This equipment is for indoor use only.

Do not operate the equipment in wet, hazardous or unstable environments.

Do not allow liguids to enter the equipment.

Do not load the equipment above it's rated capacity.

Do not drop loads on the platform.

Do not place the equipment upside down on the platform.

Use only approved accessories and peripherals.

Disconnect the equipment from the power supply when cleaning.

Service should only be performed by authorized personnel.
WARNING: Electrical shock hazards exist within the housing. The housing
should only be opened by authorized and qualified personnel. Remove all
power connections to the unit before opening.
Electrical Shock Hazard
EN-3