Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE TIMER
1
1,2,3,4
3
1
2,4
m
,/
6
. . . . ..-.-.'
The unit can be turned on at a specified
time every day with the
buil":-in timer.
Preparation
Make sure the clock is set correctly.
(See page 5.)
Use the remote control.
7 Press theTIMER button repeatedly while pressing
the SHIFT button to display 0, and press the 11
button within 4 seconds.
@
is displayed,
and the hour flashes.
I'
you do not press the 11 button within
4 seconds,
another
CIperation may start.
2 [)esignate
the hour
of the timer-on
time
by
pressing the *
or _
button or by turning the
!flULTl JOG dial, and press the 11 button. Repeat
to designate
the minute of the timer-on time.
After you designate
the timer-on
time, one of the source name
f ashes alternately
on the display.
.3 Press the FUNCTION
button repeatedly to select
a source and press the Ii button.
If the TUNER button is pressed, the band cannot be selected
in this step.
4
5
6
Select the duration for the timer-activated
period
with the +<
or
F button or the MULTI JOG
dial, and press the 11 button.
The duration for the timer-activated
period can be set between
5 and 240 minutes
in 5-minute
steps.
Prepare the source.
To listen to a CD,
load the disc.
To listen to a tape,
insert the tape into the deck.
To listen to the radio,
select the band and tune into a station.
To listen to an MD,
set the timer of the MD recorder
(with an
external
timer) and prepare
to play the MD.
To listen to the equipment
connected
to VIDEO/AUX, set
the timer of the connected source (with an external timer)
and prepare for the play.
Press the POWER button to turn the unit off after
adjusting the volume and tone.
@
remains
on the display
after the power is turned off (timer
standby
mode).
When
the timer-on
time
is reached,
the unit turns
on and
begins
play with the selected
source.
To check the specified time and source
Press the TIMER
button while pressing
the SHIFT button on the
remote control. The timer-on
time and the selected
source name
are displayed
for 4 seconds.
However, the duration
for the timer-
activated
period will not be displayed.
TIMER RECORDING
Timer recording
is applicable
for TUNER,
MD and ViDEO/AUX
(with an external
timer) sources
only.
Press the TIMER button repeatedly while pressing the
SHIFT button on the remote control so that @ and
~
appear on the display, and press the 11 button.
Repeat the steps shown above from step 2 and insert the tape
to be recorded
into the deck after step 5.
To cancel timer standby mode temporarily
Press the TIMER
button while pressing
the SHIFT button on the
remote control
so that @ (and ~)
disappear
on the display.
To restore
the timer
standby
mode,
press again
to display
@
(and ~).
Using the unit while the timer is set
You can use the unit normally
after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume
and tone.
m
Timer playback
and timer recording
will not begin
unless the
power is turned
off.
Connected
equipment
cannot be turned on and off by the built-
in timer of this unit.
Use an external
timer.
ENGLISH
16
Publicidad
