Publicidad
Idiomas disponibles
Idiomas disponibles
I
BEFORE OPERATION
SETTING THE CLOCK
POWER – -@l
DEMO
Function
PHONES
m
U
-
sensor
Remote
,.-,
— . .... . . .
To
turn the unit on
Press one of the function
buttons
(TAPE, TUNER,
VIDEO/AUX,
CD, MD).
Playback
of the inserted
disc or tape begins,
or the previously
tuned station
is received
(Direct Play Function).
The POWER
button is also available.
The disc compartment
may open and close to reset the unit.
Illumination
guides
Whenever
the AC cord is connected
or one of the function buttons
is pressed,
the buttons
for that operation
light up or flash.
Example:
When the AC cord is connected,
the II button flashes
as a guide to setting
the current
time.
After use
Press the POWER
button
to turn off the power.
The display
changes
to the clock.
MULTI JOG dial
The MULTI JOG dial can be used when tuning
in to a preset
station
or skipping
to the beginning
of a CD track. it can also be
used with the MODE
button
as a convenient
dial to adjust the
sound quality and turn Dolby NR on or off. Refer to pages
6, 8,
9, and 11 for details.
Using the headphones
Connect
headphones
to the PHONES
jack with a stereo
mini
plug (03.5 mm, l/s inch).
No sound is output from the speakers
while the headphones
are
plugged
in.
""m
1
2
3
4
5
6
II
1"""""""'"~
Ej
– CLOCK
–SHIFT
–44,
-
- II
Press
the CLOCK
button
while
pressing
the
SHIFT button on the remote control.
Within 4 seconds, press the 11 button.
The hour flashes.
To switch to the 24-hour
standard,
press the
button.
To restore the 12-hour
standard,
press the
button again.
Press the <
or W
button or turn the MULTI
JOG dial to designate
the hour.
Press the 11 button to set the hour.
The hour stops flashing
and
the minute starts flashing.
Press the +
or *
button or turn the MULTI
JOG dial to designate
the minute.
Press
the
II
button
to set the minute
and
complete
setting.
The minute stops flashing
on the display
and the clock starts
from 00 seconds.
To
set the clock without the remote control
1 Turn off the unit
if the unit is powered.
Then, if
the demonstration
display
appears,
press the
DEMO button to cancel it.
2 Press the 1I button twice so that the hour flashes.
Carry out then the steps 3 to 6 above.
To
display the current time
Press the CLOCK
button
while
pressing
the SHIFT
button on
the remote control. The time is displayed for 4 seconds.
However,
the time cannot
be displayed
during
recording.
If the clock display flashes while the power is off
This is caused
by a power interruption.
The current time
needs
to be reset.
If
power is interrupted
for more than approximately
12 hours, all
settings
stored in memory
after purchase
need to be reset.
5
ENGLISH
Publicidad
