Aiwa NSX-MA945 Manual De Instrucciones página 29

The unit can be turned on at a specified time every day with the
built-in timer,
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press one of the function buttons to select a
source.
"
If TUNER BAND is pressed, the band cannot be selected in
this step.
Press TIMER repeatedly until ~ appears on the
display.
Time and audio source name flash alternately.
o
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or [[.
Turning MULTI JOG changes both the hour and the minute.
+4 or > is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated period.
The duration can be set between 5 and 240 minutes in
5-
minute steps.
+ or * is also available instead of MULTI JOG.
5
6
7
Adjust the volume.
K
The source sound will play at the volume level set in this step ~
when the power is turned on by the timer.
If the volume level is set to 21 or higher, however, it will
'F>
automatically be set to 20 when the power is turned 011.
h'
:~,
Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
;$
To listen to a tape, insert the tape into deck 1 or 2.
g
To listen to the radio, tune in to a station.
u
Press POWER to turn off the power.
When the timer-on time is reached, the unit turns cm arid
begins play with the selected source.
m
You can change the source that was selecued in step 1 by pressing
one of the function buttons before pressing ENTER or II n step
3.
To check the timer settinlg
Press TIMER.
The selected source, the timer-on time, and the dLlration for thle
timer-activated period will be displayed for 4 seconds.
To change any of the previous settilng
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that @ disappears.
To restore the timer standby mode, press again to display @.
Using the unit while the timer ie set
You can use the unit normally after setting the tim(?r.
Before turning off the power, carry out sU?p5 and 16.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER and VI DEZO/AUX(with
an external timer) sources only.
Press either TUNER BAND or VI DEO/AUX/5.l C!H to select a
source, then press TIMER repeatedly until @RIEC Iiglhts
LIP
on the display. Within 6 seconds, carry out the steps of
"SETTING THE TIMER" from step 3 and insert the tap~?to be
recorded on into deck 2 afk?r step 6.
When the power-economizing mode (page 7) has been turned
on, the timer recording volume level will be O (minimum level).
You cannot use the timer function to record from a CD or tape.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or II is pressed within 4 seconds after
step 4.
ENGLISH
29