Sony KP-41T65 Manual De Instrucciones página 11

Connecting two VCRs for tape editing using MONITOR OUT
You can record input images displayed on the screen.
This type of connection should be used only when you
connect from the line input of one VCR, and from the
line output of a second VCR.
fags
(Rear of projection TV)
AUX
To
CONVERTER
iN
VIDEO 3 VIDEO 1
S VIDEO 5
VHF/UHF VCR (for recording)
VCR (for playback)
AUDIO VIDEO AUDIO VIDEO
Video and audio
i
by j outputs
AUDIO-R (red)
inputs
H AUDIO-L (white)
VIDEO (yellow)
VMC-810S/820S : VMC-810S/820S
(not supplied) (not supplied)
Notes .
* Do not change the input signal while editing through
¢ When connecting a single VCR to the projection TV, do not
MONITOR OUT, or the output signal will also change.
connect the MONITOR OUT to the VCR's line input, while at
¢ You can use the S video jack to-connect a VCR for playback the same time connecting from the projection TV's VIDEO IN
and the composite video connector to connect a VCR for
connectors to the VCR's line output, as shown below.
recording.
(Rear of projection TV)
VIDEO IN rT] i MONITOR)
OUT
DO NOT CONNECT IN THIS WAY.
Getting Started | 17-EN