Descargar Imprimir esta página

Porter Cable C2550 Manual De Instrucciones página 20

Compresor de aire transmisión directa con aceite portátil formato panqueque

Publicidad

Idiomas disponibles

Idiomas disponibles

Before you store the air compressor, make sure you do the following:
1.
Review the "Maintenance" section on the preceding pages and perform
scheduled maintenance as necessary.
2.
Set the On/Auto/Off lever to "OFF".
3.
Turn the regulator counterclockwise and set the outlet pressure to zero.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing air to bleed from the tank until tank
pressure is approximately 20 psi. Release safety valve ring.
6.
Drain water from air tank by opening drain valve on bottom of tank.
tank rupture.
7.
After the water has been drained, close the drain or drain valve.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, then reinstalled.
8.
Loosen knobs on handle and fold handle down for storage. Retighten
knobs.
RECOMMENDED HANDLE
STORAGE
9.
Protect the electrical cord and air hose from damage (such as being
stepped on or run over). Wind them loosely around the compressor
handle.
10. Store the air compressor in a clean and dry location.
D28093
STORAGE
Water will condense in the air tank. If not drained, water
will corrode and weaken the air tank causing a risk of air
ALTERNATE HANDLE STORAGE
20- ENG

Publicidad

loading