Descargar Imprimir esta página

MSW Motor Technics MSW-PLT-W20 Manual De Instrucciones página 40

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 127
E2 - smoke sensor (thermocouple) does not work
E3 - no ignition or the flame went out automatically during operation, the stove will go into the
shutdown procedure
E4 - exhaust gas temperature is too high, the stove will go into shutdown procedure
E5 - the water tank temperature is too high, the stove will go into shutdown procedure
3.4.
Cleaning and maintenance
a)
Before cleaning, replacing accessories, and when the machine is not in use, turn it off, unplug
it and cool it down.
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Do not spray the unit with a stream of water or immerse it in water.
d)
Make sure that no water enters through the ventilation openings in the casing.
e)
Clean the ventilation openings with a brush and compressed air.
f)
Perform regular inspections of the unit checking technical fitness and any damages.
g)
Do not leave the batteries in the remote control when it will not be used for a long time.
h)
Do not clean the device with acidic substances, medical products, thinners, fuel, oil or other
chemicals as this may damage the device.
EN

Publicidad

loading