Publicidad
Idiomas disponibles
Idiomas disponibles
2 SAFETY RULES
2-1. Notes when using the nylon-cutting head and 3 teeth blade.
1. The grass trimmer was designed to cut grass and small weeds. Never use the trimmer for any other purpose.
2. Use nylon cutting heads that meet the trimmer rotation rate requirements. Use nylon cords designated for the nylon
cutting heads.
3. After starting the engine, pull the throttle lever gradually. The engine speed increases and the nylon-cutting head
or 3 teeth blade will start rotating.
4. When the throttle lever is released, the engine goes back to idle speed automatically.
5. Operate the unit at full throttle while cutting. Best fuel efficiency is obtained by releasing the throttle when swinging
back after cut.
6. The blade rotates counterclockwise. For best performance and to minimize being stuck by debris, move the blade
from right to left while advancing on your work.
2-2. Notes when using the unit.
1. Wear close fitting, tough work clothing that will provide protection, such as long slacks or trousers,
safety work shoes, heavy duty work gloves, head protector( helmet ), a safety face shield, or safety goggles for eye
protection and a good grade of ear plugs or other sound barriers for hearing protection.
2. Refill in a safe place. Open fuel cap slowly to release any pressure which may have formed in fuel tank. To prevent a fire
hazard, move at least 3 meters from fueling area before starting.
3. Comply with all fire prevention regulations. Compliance with all local, state, or European law is the user's responsibility.
Your unit comes with a spark arrester screen furnished in the user kit. Replacement spark arrester screen kits are available
from distributor.
4. Turn off the unit before setting it down.
5. Always hold unit firmly with both hands, the thumb and fingers encircling the handles.
6. Keep all screws and fasteners tight. Never operate your equipment when it is improperly adjusted or not completely and
securely assembled.
7. Keep handles dry, clean and free of fuel mixture.
8. Keep cutting-head as close to ground as practical. Avoid hitting small objects with cutting-head. When cutting
on a slope, stand below cutting-head. Never cut or trim on a hill or slope, etc. if there is the slightest chance of slipping,
sliding or losing firm footing.
9. Check area you will be trimming for debris that may be struck or thrown during operation.
10. Keep all parts of your body and clothing away from cutting-head when starting or running engine. Before starting
engine, make sure cutting-head will not come in contact with any obstacle.
11. Stop engine before examining cutting line.
12. Store equipment away from possible ignition sources, such as gas-powered water heaters, clothes dryers, or oil-fired
furnaces, portable heaters, etc.
13. Always keep the debris shield, cutting-head, and engine free of debris build-up.
2
Publicidad
