KURIL K828 Instrucciones De Uso Y Mantenimiento página 34

2. Screw the nylon line cutting attachment securely. Fig.9
3. Mount the shaft nut on the nylon cutting attachment head.
4. Remove the nylon line cutting attachment tightening nut and cup washer from gear housing.
5. Insert the upper clamp and lower clamp into the gear housing.
6. Then insert an Allen wrench 4 mm in the holes to stop moving the clamp. Fig.10
7. Tighten the nylon cutting head counterclockwise with hand into the gear housing.
8. Remove the Allen wrench 4 mm.
For blade cutting attachment
1. Match the hole in the side of the cutting attachment guard with the hole in the side of the gear housing.
2. Screw the blade cutting attachment securely. Fig.11
3. Mount the shaft nut on the blade cutting attachment head.
4. Remove the blade cutting attachment, tightening nut and cup washer from gear housing.
5. Insert the upper clamp and lower clamp into the gear housing.
6. Then insert an Allen wrench 4 mm in the holes to stop moving the clamp. Fig.12
7. Tighten the blade cutting head counterclockwise with hand into the gear housing.
8. Remove the Allen wrench 4 mm.
9. Blade when stop using, please to store well with blade protect cover. Fig. 13
8.EXAMPLE OF FUEL - MIXING
8-1 Fuel mixing
Use unleaded gasoline containing 4%, 2 cycle engine oil (50:1), reference table.
Gasoline 2 cycle oil
1L 20 c.c.
4L 80 c.c.
5L 100 c.c.
Fig. 9
1. Use a container mix gasoline with 2 cycle engine oil.
Do not mix them in the fuel tank directly.
Wipe off spilt fuel immediately.
2. Do no use old mixed fuel because it has deteriorated and adversely
affects the engine.
Fig. 10 Fig. 11
WARING
8
Fig. 12
Fig. 13