GE PGP990 Manual Del Usuario página 10

Surface burner and grill modules.
Throughout this manual, features and appearance may vary from your model.
Sealed Burner Module
To Install the Sealed Burner Module:
1. Hake sure that all control knobs are set 4.
to OFF.
.
3.
Cleanthe cooktop basin to remove any
grease accumulation. Seethe Coreand
Cleaningthe Cooktop section.
With the back of the burner module
tilted up and the two round openings
and three pins facing toward the front,
insert the module in the cooktop basin.
5.
.
Slidethe burner module forward until
the pins start to engage the white
slotted receptacle.
Lower the back of the module into place
and carefully slide it forward until the
pins are fully engaged.
Placethe burner caps on the burners.
Carefully place the grate onto
the module with the two tabs
on the underside toward the
center of the cooktop.
To Remove the Sealed Burner Module:
.
.
Make sure that all control knobs are set
to OFFand that the cooktop is cool.
Lift up the edge of the burner module
until the bottom of the module clears
the edge of the basin.
IMPORTANT: Do not lift the module too
high while it is still connected-you could
damage the ignitor rods and mixer
tubes.
]. Hold the module by the sides and pull it
away from the slotted receptacle and
brass orifices. Lift it out of the basin
when it is completely unplugged.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE:The optional sealed burner module
JXGBg0can replace the grill burner
assembly.
10
Grill Module
Thegrill consistsof o block grill grote and the grill burner. Only install the grill on the left side
of gout cooktop.
To Install the Grill Module:
.
.
3.
Hake sure that all control knobs are set
to OFF,
Position the grill burner with the two
round tubes and three pins facing
the front.
Slidethe grill burner forward until
the pins and ignitors are engaged in
the white slotted receptacle; then
lower the burner until it rests on
the mounting pins.
4. Carefully place the grill grate on
the cooktop, The grate is designed to fit
one way only. Seethe illustration.
NOTE:Before using the grill for the first
time, heat the grill burner to remove the
protective shipping coating. Heat the grill
burner on HI for JOminutes and use the
vent system to remove any additional
smoke during cooling.
To Remove the Grill Module:
1. Make sure that all control knobs are set
to OFFand all grill components are cool.
2. Removethe grill grate.
]. Lift the grill burner up slightly and pull it
away from the white slotted receptacle
and brass orifices. Lift it out of the basin
when it is completely unplugged.
4. Do not store or stack modules where
they could fall or be damaged,
NOTE:The optional sealed burner module
JXGBg0can replace the grill burner
assembly.