GE PGP990 Manual Del Usuario página 34

Before you call for service...
Troubleshooting Tips
Save time and moneg! Review the charts on the following
pages first and gou mog not need to call for service.
Burners do not light
Possible Causes
Plug on cooktop is not
completely inserted in the
electrical outlet.
What To Do
• Hake sure electrical plug is plugged into a live, properlg
grounded outlet.
Gas supply not connected • Seethe Installation Instructions section.
or turned on.
A fuse in your home mag be • Replacethe fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
Igniter orifice in burner bodg • Removethe obstruction.
mag be clogged.
Burner parts not replaced • See Sealed Burner Hodules in the Core and cleaning
correctly, of the cooktop section.
Slits in the burner head mag • Use a small sewing needle or paper clip to unplug.
be clogged.
Burners have yellow or
yellow-tipped flames or
flames rift off the port
The combustion quality
of burner flames needs
to be determined visually.
A-Yellow flames
Coil for service
B-Yellow tips on C-Soft blue flames
outer cones Normal for natural
Normal for LP gas gas
Burner parts not replaced
correctly.
If burner flame looks like A, call for service. Normal
burner flames should look like B or C, depending on
the type of gas.
NOTE:The grill burner will show orange flames from
grease drippings.
• See Coreand cleaning of the cooktop section.
Burnerflames make
excessive noise
Burner has not been used
recently.
• A "cold" burner ignited in the HI setting may have
some flame "roar" or "lifting." This should dissipate
after 4 to 5 minutes.
Burner flames pulled Vent fan set at HI speed.
toward vent grille
• This is normal. If cooking performance is affected,
change fan to a lower fan speed setting.
34