When Connecting Refrigerant Tubing
• When performing piping
work do not mix air except
for specified refrigerant
(R410A) in refrigeration
cycle. It causes capacity
down, and risk of
explosion and injury due
to high tension inside the
WARNING
refrigerant cycle.
WARNING
• Refrigerant gas leakage
may cause fire.
• Do not add or replace
refrigerant other than
specified type. It may
cause product damage,
burst and injury, etc.
• Ventilate the room well, in the event
that is refrigerant gas leaks during
the installation. Be careful not to allow
contact of the refrigerant gas with a
flame as this will cause the generation
of poisonous gas.
• Keep all tubing runs as short as
possible.
• Use the flare method for connecting
tubing.
• Apply refrigerant lubricant to the
matching surfaces of the flare and union
tubes before connecting them, then
tighten the nut with a torque wrench for
a leak-free connection.
• Check carefully for leaks before starting
the test run.
• Do not leak refrigerant while piping work
for an installation or re-installation, and
while repairing refrigeration parts.
Handle liquid refrigerant carefully as it
may cause frostbite.
When Servicing
• Turn the power OFF at the main
power box
(mains) before opening the unit to check
or repair electrical parts and wiring.
• Keep your fingers and clothing away
from any moving parts.
• Clean up the site after you finish,
remembering to check that no metal
scraps or bits of wiring have been left
inside the unit being serviced.
• This product must not be
modified or disassembled
WARNING
WARNING
under any circumstances.
Modified or disassembled
unit may cause fire,
electric shock or injury.
• Do not clean inside
the indoor and outdoor
units by users. Engage
authorized dealer or
specialist for cleaning.
• In case of malfunction
of this appliance, do not
repair by yourself. Contact
the sales dealer or service
dealer for repair.
• Do not touch the air
inlet or the sharp
CAUTION
WARNING
aluminum fins of the
outdoor unit. You may get
injured.
• Ventilate any enclosed areas
when installing or testing the
refrigeration system. Escaped
refrigerant gas, on contact
with fire or heat, can produce
dangerously toxic gas.
• Confirm after installation that
no refrigerant gas is leaking.
If the gas comes in contact
with a burning stove, gas
water heater, electric room
heater or other heat source,
it can cause the generation
of poisonous gas.
Others
• Do not sit or step on
CAUTION
WARNING
the unit, you may fall
down accidentally.
• Do not touch the air
inlet or the sharp
aluminum fins of the
outdoor unit. You may
get injured.
• Do not stick any object
into the FAN CASE.
You may be injured
and the unit may be
damaged.
NOTICE
The English text is the original instructions. Other
languages are translations of the original instructions.
3