Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE INSTRUCTIONS
! DANGER: no maintenance work of any
isolated the machine from its power source.
Maintenance operations on the electrical circuit
— and in any event, all other operations not
explicitly described in this operating manual —
must be performed by a TENNANT approved
service technician, in compliance with current
safety regulations and as indicated in the
maintenance manual.
Maintenance - General rules
Performing
regular
maintenance
Manufacturer's instructions will improve performance and
extend the working life of the machine.
When cleaning the machine, always observe the following
precautions:
Avoid using pressure washers. Water could penetrate the
electrical compartment or motors leading to damage or
short circuits;
Avoid using steam, as the heat could cause the deformation
of plastic parts;
Do not use solvents or hydrocarbon based products.
These can damage the cowling and rubber components.
correct operation of the machine. Proper maintenance
-
Using the automatic cleaning system, the machine
is programmed for automatic and cyclical cleaning
predetermined intervals.
! NOTICE
NOTE: the automatic cleaning system can be
enabled/disabled in the machine software menu; refer
The machine is factory-set with the system
DISABLED
-
Using the manual cleaning system; press
for a few seconds. Repeat this operation
4
or
5
times
This operation should be performed at the end
of every working shift. If the machine is used in
a dusty environment (e.g. sawmills, warehouses
where vehicles are moving back and forth, etc.),
according
to
while
using
the
machine.
-
does not produce the expected result, clean the
least once every 50 working hours.
! ATTENTION: before carrying out the operations
apply the parking brake.
the
-
Take out the debris bin and empty it; refer to the
section
-
-
Undo the four screws and remove the two
clamp brackets, taking care to unplug the power
-
-
(maximum pressure 6 bar - 87 PSI).
-
EN
22
Publicidad
