Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING
1C. FAN AND LIGHT CONTROLLED BY
TWO WALL SWITCHES: If you intend to
control the fan and light with separate wall
switches, connect BLACK wire from fan to
BLACK wire from the independent wall
switch for the fan. Connect BLUE wire from
fan to the BLACK wire from the other
independent wall switch for the light.
Connect WHITE wire from fan to WHITE
wire from ceiling. Connect all GROUND
(GREEN) wires together from fan (on
downrod (D) and mounting bracket (A)) to
BARE/GREEN wire from ceiling.
NOTE: BLACK wire is hot power for fan.
BLUE wire is hot power for light kit. WHITE
wire is common for fan and light kit. BARE/
GREEN wire is ground.
2. Wrap electrical tape (not included) around
each individual wire connector (AA) down to
the wire.
WARNING: Make sure no bare wire or
wire strands are visible after making
connections. Place GREEN and WHITE
connections on opposite side of box from
the BLACK and BLUE (if applicable)
connections.
Turn spliced/taped wires upward and gently
push wires and wire connectors (AA) into
outlet box.
Hardware Used
Wire Connector
3. IMPORTANT: Using a full range dimmer
switch (not included) to control fan speed
will cause a loud humming noise from fan.
To reduce the risk of fire or electrical shock,
do NOT use a full range dimmer switch to
control fan speed.
x 4
11
FAN AND LIGHT CONTROLLED BY TWO WALL SWITCHES
FAN AND LIGHT CONTROLLED BY TWO WALL SWITCHES
1C
120V POWER
FROM CEILING
BLACK (POWER)
WHITE (NEUTRAL)
GROUND/GREEN (BARE)
GREEN
WHITE
2
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
BLACK
(WALL
SWITCH)
BLACK
BLACK
BLUE
3
2
1
Speed
Switch
Publicidad
