Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
1.
Make sure connections are neatly tucked
into the ceiling outlet box.
Slide the canopy (B) up to the mounting
bracket (A) and place the key holes on the
canopy (B) over the loose canopy mounting
screws on the mounting bracket (A). Turn
the canopy (B) clockwise until it locks in
place at the narrow section of the key
holes. Make sure the positioning pin (OO)
on the mounting bracket falls into one of
two holes on the canopy (B), and then
tighten the two canopy mounting screws.
2.
Attach the canopy bottom cover (C) to the
canopy (B) by inserting the screw heads
into the key slots in the canopy bottom
cover (C) and rotating it clockwise.
NOTE: Adjust the canopy mounting screws
as necessary until the canopy (B) and
canopy bottom cover (C) are snug.
3.
Attach the blades (J) to the blade arms (K)
using the three blade attachment screws
(BB) and fiber blade washers (CC). Insert a
blade attachment screw (BB) and fiber blade
washer (CC) into the blade arm (K), but do
not tighten. Repeat for the two remaining
screws (BB) and fiber blade washers (CC).
Tighten each screw securely starting with
the center screw. Make sure the blade (J)
is straight. Repeat these steps for the
remaining blades.
Hardware Used
Blade Screw
Fiber Blade Washer
x 15
x 15
1
Positioning Pin
2
Canopy
Mounting
Screw
3
12
Canopy Mounting
Screw
+
Publicidad
