GE PHP900 Manual Del Propietário página 13

Using the surface elements, ge.co
Error Alerts (Flashing "E"/"c" and "E" "o")
Error alerts indicate a temporary problem Touch the ON/OFF pad and allow the
that may be corrected by the useE
Clear Keypad-If the display flashes "E"
alternating to "c', the keypad is sensing
continuous activation of one or more
keypads. Cleanor clear any obstructions
on the keypad area. Obstructions may be
water, food spills,a utensil or other objects.
To resume cooking, touch the ON/OFF pad,
then select the power level.
Over Temperature-If the display flashes
"E" alternating to "o', the cooktop sensor
indicates that the induction element or
electronics have overheated.
cooktop to cool for B0 to 45 minutes before
operation can begin again.
If either of these conditions persist,
call for service.
IMPORTANT: If the "E" flashes alone,
without alternating to a "c" or "o', a
hardware error has occurred. Call for
service.
Overheating of the element is caused by
placing an empty pan on the element and
selecting a high power level.The element
sensor detects very high temperatures
(above normal cooking temperatures),
turns off the power and displays the erroE
A second potential cause of this error is
a lack of cooling air to the bottom of the
cooktop, which can cause overheating
of the electronics. If this situation occurs,
make sure the air inlet below the cooktop
is unobstructed.
m
CONTROL
LOCK
Control Lock
IMPORTANT: As a convenience, you can
lock the entire cooktop at any time when it
is not in use or before cleaning. Locking the
cooktop will prevent surface elements from
being turned on accidentally.
To lockthe cooktop:
Touch and hold the CONTROL LOCKpad
for 5 seconds.
A two-beep signal will sound, and the
CONTROL LOCKlight will glow, indicating
that the cooktop is locked.
If the cooktop is locked while a surface
element is in use, it will automatically
turn off.
The CONTROL LOCKdoes not affect the
timer If Control Lock is set while the timer is
counting down, it will continue to operate.
To unlock the cooktop:
Touch and hold the CONTROLLOCKpad
again for 5 seconds. A two-beep signal will
sound, and the CONTROLLOCKlight will
go out, indicating that the cooktop is
unlocked.
13