GE PHP900 Manual Del Propietário página 16

Cleaning the glass cooktop.
Clean your cooktop after
each spill. Use CERAMA
BRYTE ® Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
Use CERAMA BRYTE ® Ceramic Cooktop
Cleaner on the glass cooktop.
To maintain and protect the surface of
gour glass cooktop, follow these steps:
[] Before using the cooktop for the
first time, cleon it with CERAMA
BRYTE ®Ceramic Cooktop Cleaner.
This helps protect the top and makes
cleanup easier.
[] Dailg use of CERAMA BRYTE ®Ceramic
Cooktop Cleanerwill help keep the
cooktop looking new.
Shakethe cleaning cream well. Applg
[] a few drops of CERAMA BRYTE ®
Ceramic Cooktop Cleaner directlg
to the cooktop.
[] Use a paper towel or CERAMABRYTE ®
Cleaning Pod for Ceramic Cooktops to
clean the entire cooktop surface.
[] Use a drg cloth or paper towel to
remove all cleaning residue. No
need to rinse.
NOTE: It is verbl important that you DO
NOT heat the cooktop until it has been
cleaned thoroughlg.
Burned-On Residue
ii i
WARNING: DAMAGEto gour glass surface
may occur if blou use scrub pads other
than the pod included with blour cooktop.
Use a CERANA BRVTE ® Cleaning
Pad for Ceramic Cooktops or a
Scotch-Brite ® Multi-Purpose No
Scratch blue scrub pad.
[] Allow the cooktop to cool.
[] Spread a few drops of CERAMA
BRYTE ®Ceramic Cooktop Cleaner
on the entire burned residue area.
[]
Using the included CERAMA BRYTE ®
Cleaning Pad for Ceramic Cooktops,
rub the residue area, applging
pressure as needed.
[]
[]
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
The CERAMABRVTE ¢ Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under
"To Order Parts" section on
next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
[] Allow the cooktop to cool.
[] Use a single-edge razor blade
scraper at approximatelg a 45 °
angle against the glass surface
and scrape the soil. It will be
necessarg to applg pressure
to the razor scraper in order
to remove the residue.
[] After scraping with the razor
scraper, spread a few drops of
CERAMABRYTE ® Ceramic Cooktop
Cleaner on the entire burned residue
area. Use the CERAMA BRYTE ®
Cleaning Pad to remove ang
remaining residue.
[]
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
16