Brandt UFB 1000 E Libro De Instrucciones página 23

Grid preparation
Remove the grid from the appliance pulling it towards
you with hands.
S.I.001
Right door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure, a).
S.I.002
Left door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure, b).
To reposition the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by pushing
the clasps (a) until they click.
N.B. The grid is to be assembled after having fixed
the appliance in the niche with the brackets.
a
a
a
A
b
Door reversal
The appliance must be unplugged before
starting work. To reverse the opening direction of the
door, proceed as follows:
1. Remove the top hinge (1) taking care not to let the
door fall.
2. Remove the bottom door hinge (2).
3. Take out the plugs (3) from the holes (F) and
reinsert them in the holes (F
side.
4. Refit the upper hinge (1) on the opposite side, on
the bottom (position A).
5. Refit the door on the pin of the hige (1) in position
A;
B
6. Insert the pin of the previously removed bottom
hinge (2) in the upper hole (G) of the door,
therefore fix the hinge on the top in position B.
Building the appliance in under a
worktop
The dimensions of the recessed installation area must
correspond with those indicated in the figure.
The appliance could be inserted between two units
(a) or as an end unit (b).
23
F 1
F
1
B
3
F1
F
2
A
S.I.003
) on the opposite
1
b
S.I.004
G
a