Generac iX 1400 Manual Del Usuario página 6

SPECiFiCATiONS
Engine Type........................ SingleCylinder, 4 -Stroke
EngineSize....................................... 80c0
StarterType ...................................... Recoil
FuelCapacity/Type . ................ 0.73 Gal (2.77 L)/Unleaded
Oil Capacity ................................ 0.03 Qt (O.TL)
RuntimeFull/HalfLoad........................ 2.5/5.0 Hours
SparkPlugType ................................. BPR7HS
SparkPlugGap ..................................... 030"
Dimensions L x Wx H (in) ...................... 22 x 12 x 18
WeightLb/kg ................................. 46.0/20.09
MaximumACOutput.............................. 1400W
SurgeACOutput ................................. 1450W
ACVolts....................................... 120 VAC
RatedACCurrent . ................................. 11.6 A
Frequency....................................... 60 Hz
THD............................................. 3.0%
InsulationClass.................................. ClassB
Outlets .............................. (2) 5-15R, (1) 12 VDC
DCVolts ........................................ 12 VDC
RatedDCCurrent . ................................... 5 A
NOTE:
Power output and runtime are influenced by many factors,
someof whichare fuel quality, ambienttemperatureand engine
condition. O utput decreases approximately 3.5% for each 1,000
feet abovesea level and 1% for every 10 degrees above60°F.
EMISSIONSINFORMATION
The Environmental Protection Agency (EPA) and California Air
Resource Board (CARB) requirethat your generatorcomply with
exhaust and evaporative emission standards. This generator is
certified to meet the applicable EPA and CARB emission levels.
Additional information regardingthe requirementsset by EPAand
CARBis as follows:
It is important that you follow the maintenance specifications
provided in this manual to ensurethat your enginecomplies with
the applicableemission standardsfor the durationof the engine's
life. This engine is certified to operate on gasoline. The emission
control system on your generatorconsists of the following:
• FuelSystem • Air Induction System
FuelTank - Intakepipe/manifold
FuelCap _ Air cleaner
Carburetor • Ignition System
FuelLines - Spark plug
• EvaporativeControl System _ Ignition module
CarbonCanister • ExhaustSystem
Vapor Hoses _ PulseAir InjectionValve
Muffler
The Emissions Compliance Period referred to on the Emissions
Compliance Label indicates the number of operating hours for
which the engine has been shown to meet Federaland California
emission requirements. See the table below to determine the
compliance period for your generator.The displacement of your
generatoris listed on the Emissions ComplianceLabel.
UNiTIDENTIFICATION (Figure 2)
1. Carrying Handle: Lift the generatorby this handleonly.
2. Spark Plug Cover:Allows access to the engine spark plug.
3. Fuel System Primer: Used to prime the fuel system for
starting.
4. Fuel Cap PressureValve: Allows air to enter the fuel tank to
equalizepressure.
5. FuelTankCap: Access to fuel tank for filling.
6. Control Panel: location of generator controls and output
receptacles.
7. Air IntakeSlats: Allows for cooling air to enterthe housing.
8. Muffler: Lowers engine exhaust noise (includes the spark
arrestor).
9. Choke:Cold engine starting aid
10. Left Side Service Cover: Allows access to air filter, fuel filter
and oil fill.
11. VentHoses: Hosesallow venting of the carburetor.
12. FuelShutoff: Controls fuel supply to the carburetor.
13. Starter Rope: Pull rope for starting engine.
Figure 2- Unit Identification
1
\
8\
12
11
10
9