Generac iX 1400 Manual Del Usuario página 9

*Garage Door Opener ........................... 500 to750
Hair D ryer ........................................ 1200
Hand D rill ................................... 250 to11 O0
Hedge Trimmer ..................................... 450
Impact Wrench ..................................... 500
Iron ............................................. 1200
*Jet P ump ......................................... 800
Lawn M ower ...................................... 1200
Light Bulb ......................................... 1O0
Microwave Oven . ............................ 700 to1000
*Milk Cooler ...................................... 1100
Oil B urner onFurnace ................................. 300
Oil F ired Space Heater (140,000 Btu) . .................... 400
Oil F ired Space Heater (85,000 Btu) . ..................... 225
Oil F ired Space Heater (30,000 Btu) . ..................... 150
*Paint Sprayer, Airless (1/3 HP) ......................... 600
Paint Sprayer, Airless (handheld) ........................ 150
Radio ........................................ 50to200
*Refrigerator ....................................... 700
Slow Cooker ....................................... 200
*Submersible Pump ( 1-1/2 H P) ........................ 2800
*Submersible Pump ( 1HP) . .......................... 2000
*Submersible Pump ( 1/2 HP) .......................... 1500
*Sump P ump ................................ 800 to1050
* Allow t hree (3) t imes the listed running watts for s tarting theses devices.
NOTE:
When an electric motor is started,the "OVERLOAD" L ED may
light up for up t0 five (5) seconds(this is n0rmal), if it stays on,
a fault has0ccured. Removeall loadsand shutdown generator
to reset the alarm. Restart the generator. If the "OVERLOAD"
LED remainslit, contacta GeneracDealerfor assistance.
USINGTHEFLEXPOWER
TM
SWITCH
When the accessories connected to the generator are going to
be used intermittently (such as a hand drill), the FtexPower
TM
switch can be pushedto the "ON" (I) position. This will lower the
generatorengine speed when loads are not being applied,saving
fuel, reducingengine wear and extendingruntime.
USING THE 12 VDCBATTERY CHARGER
The 12 VDC receptacle may be used to recharge 12 VDC
automotivebatteriesonly. TheDC chargingoutput is not regulated.
The circuit protector does not preventover-charginga battery.
1. Connect the charging cable to the generatorfirst, then the
battery, ALWAYSconnectingthe red lead to positive (+) and
the black to negative (-).
Do not permit smoking, open flame, sparks
or any other source of heat around a battery.
Wear protective goggles, rubber apron
and rubber gloves when working around
a battery. Battery electrolyte fluid is an
extremely corrosive sulfuric acid solution
that can cause severe burns. If a spill occurs,
flush area with clear water immediately.
Storage batteries give off explosive hydrogen
gas white recharging. An explosive mixture
wiii remain around the battery for a long
time after it has been charged. The slightest
spark can ignite the hydrogen and cause an
explosion. Such an explosion can shatter the
battery and cause blindness or other serious
injury.
,_ NEVER reverse the polarity when connecting
the battery terminals to the charging jack.
Severe damage may occur to the generator
and battery.
2. Keepthe FlexPower
T M
switch in the "OFF"(O) position.
3. Start the generatorand use it as normal. Chargingtime will
vary with batterysize and condition. Checkthe voltage at the
batteryterminals oncethe charging cablehas been unplugged
or the generatorhas been shut down.
NOTE:
Thisreceptaclecan not recharge5-V01t batteries and can not
be used to crank an engine having a discharged battery.
SHUTTING D OWN
Oncethe generatoris no longer neededit can be shut down.
1. Switch off any accessoriesconnectedto the generator.Unplug
any cords to the 120 VAC duplexoutlets or the 12 VDC plug.
2. Turn the fuel valve to the "OFF" (0) position (Figure 7). A
switch behind the fuel valve grounds the ignition system,
stopping the engineand the fuel supply is shut off.
3. Close the vent on the fuel cap.
4. Allow the generatorto cool beforemoving or storing.
ACAUTION!
,_t Always allow the generator to cool off before
storing. High temperatures will be present
at the rear of the unit for some time after
shutdown.
Figure 7- Turn Off Fue/