Publicidad
5
@
1. Belt guard
2. Screw
3. Screw
4. Hairpinclipand retainingpin
5. Hex nut (located behind tire)
6. New tine
7. Worn tine
8. Sharp edge
9. Hairpin clip
10. Retaining pin
Figure 18
1
Figure
19
6
7
Ground drive belt replacement
a, Remove hairpinclip and retainingpin(fig. 18) from hub
of lefthandwheel. Pullwheel Outfrom tillerabout 1-1/2
inches,
b. Remove belt guard by removing two (2) screws,one (1)
hexnutandthree (3) washerssothatbeltguardcanslide
straightout away from engine(fig. 18).
c. Loosenbelt guide (fig.17-inset)
d. Remove old belt by slippingfrom idler pulley (fig. 17)
first.
e.
Place new belt in groove to transmission pulley (large pul-
ley) and into groove of engine pu!ley (fig. 17). Belt must
be in groove on top of idler pulley (fig. 17). Note positon
of belt to guides.
f.
Tighten belt guide (fig. 17 -inset)
Tine replacement
A badly worn tine causesyour tillerto work harder and dig
shallower.Mostimportant, w orntinescannotchopandshred
organicmatteras effectively nor buryit as deeply as good
tines. A tine this worn(fig.19) needs to be replaced.
To maintain the superb tilling performance fo this machine the
tines should be checked for sharpness, wear and bending
particulary the tines which are next to the transmission (fig.
20). If the gap between the tines exceeds 3-1/2 inches, they
should be replaced or straightened as necessary,
New tines should be assembled as shown in figure 21. Sharp-
ened tine edges will rotate rearward from above (fig. 21).
CAUTION!
Never temper withthe engine governor, w hichis factoryset
for properengine speed,
Figure 21
8
9
Counter Une
rotation
Figure 20
Tine
i
3-1/2"
max.
10
49
Publicidad
