Worx WG284E Manual Original página 11

NOISE INFORMATION
A weighted sound pressure
A weighted sound power
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 62841:
Vibration emission value: a
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
Hedge trimmer
L : 77.2 dB(A)
pA
K = 3 dB(A)
pA
L : 93.1 dB(A)
wA
K = 3 dB(A)
wA
< 1.5 m/s²
h
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4. OPERATING INSTRUC-
TIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
Checking the battery charge condition
NOTE : Fig. C only applies for the
battery pack with battery indicator
light.
Charging the battery pack
NOTE :
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
FIGURE
11
See Fig. A
See Fig.
B1, B2
See Fig. C
See Fig. D
EN